What can I do when logged in?

You can submit new articles, so we can make unique versions of them and distribute them for you.
If you want to simply publish the same article on 800 websites, you can tell us to do that.
You can see the archive and current status of all your article distributions.
You can order any number of high-quality articles - just let us know your keywords.
You can browse the archive of all the articles we have written for you.
You can order our Complete Service (10 high-quality articles plus 10 article distributions).
You can purchase more credits for our services and check your affiliate earnings.
Much more ...

SpinDistribute.com Article Directory

The following article was published in our article directory on December 9, 2009.
Learn more about SpinDistribute Article Distribution System.

What to use to weight a reborn doll

Article Category: Arts and Crafts

It is a common problem for some reborners to hit a stumbling block when trying to get the right weight for a reborn doll. As with some of the other reborning processes there are many ways you can fill the doll and various mediums you can use to fill it, but one of the most important aspects is actually getting the weight correct and balanced throughout the doll as it adds to the realism.

Typically, you can fill the limbs and body with fiberfill, polyfill, baby fat pellets or fine sand. It is probably easiest to align the weight correctly using sand, but it does also come with various problems and many have stopped using sand now, although some new artists still do so. The sand is poured into small bags and secured inside each limb and the body. This helps to keep the weight distributed evenly and they may need to be padded inside to keep them in place.

More often than not, however, one of the bags inevitably ends up splitting or leaking, and not only does this end up leaving a mess but it distorts the weight too. Since sand can and will get everywhere it will also leave a mess which is more of a nuisance than anything else, however, if the doll is to be taken or shipped oversea's, then sand can also be rejected from customs which is worth bearing in mind.

Polypellets and glass beads are perhaps the most commonly used to weight a reborn doll at the moment. They are not only easy to use, but they are also quite cheapto buy in bulk so you will never be short and are far less likely to fall out of tiny holes. They are stored in much the same way as sand, inside small bags or pouches that are padded with fiberfill to keep them in place.

Baby fat pellets aren't as common but if used properly can add a more realistic feel to the reborn doll. However, again, you may run into problems with them since they can react badly to some forms of silicon that is often used in the dolls limbs. This can put many people off so there is a trade off, however, a few people have reported good results when storing the pellets inside fabric or nylon bags inside the body with no bad effects from it.

Keywords: reborn dolls, polypellets, fiberfill, baby fat pellets, reborn babies, reborning

Learn more about SpinDistribute Article Distribution System. We also offer Professional Article Writing to everyone who's looking for high quality web content.

SpinDistribute.com Network

Each article you submit at SpinDistribute.com is sent through our innovative Article Distribution System to our network of more than 1840 publishers - about 55% of them are high-quality article directories, 30% of them are niche blogs and 15% of them are other content-rich websites.

To achieve the best possible success we only publish your article to most related websites. This means your article will show up on approximately 640 - 880 most related websites which will give you great SEO results.

We also offer a separate Professional Article Writing Service to everyone who's looking for high quality web content and well researched unique articles.